Barry,
I just tried a test into the dummy load using split between bands and
also within bands. With CW the rig will shift between bands - with a
similar delay as you mention- but I cannot send CW other than a one time
"dit", regardless of which direction the shift is made. On phone the
shift works very quickly and no problems occur. When using shift within
any band there is no problem with either phone or CW and the shift is
faster than I can guess. Of course it's not likely I would be working
split between bands in any mode. I didn't check the manual to see what
it says.
73, Troy, W6HV
N1EU wrote:
> Just noticed that when releasing PTT in my Omni 6 (opt
> 3) when in split mode, there is about a half sec delay
> in changeover to receive. No such delay when not in
> split.
>
> I never noticed this before, but perhaps it was always
> there. Would appreciate knowing what others see with
> their rigs, or perhaps there is a simple explanation?
>
> Tnx & 73,
> Barry N1EU
>
> =====
>
> __________________________________________________
> Do You Yahoo!?
> Bid and sell for free at http://auctions.yahoo.com
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|