Meant to send this to the reflector...
--------- Forwarded message ----------
Bill,
You should be able to place the STANDBY switch in that mode and transmit
without the amp on. If it's not working that way, then there is a
problem. (I had TenTec check this specifically before I bought mine to
make sure the logic was correct.)
73, Duane AC5AA
On Mon, 11 Oct 1999 18:51:45 -0700 Bill Capps <wbcapps@mindspring.com>
writes:
>
> hello
> i have recently purchased a CENTUAR and i have it hooked up
> to my paragon
> 1.I use this amp mainly for 160 and 80 meter dx work. I have yet to
> use it
> on any of the other bands.
> i have a problem, that i cant fiqure out. I am unable to
> key my paragon
> (i'm cw only), without first turning on the centuar, and placing it
> in the
> "standby mode".
> i enjoy working the others bands like 20/15/10 but it is a
> headache to
> have to crank up the amp (and listen to the blower motor) , when
> running
> 100 watts is all that is needed.
> i have read through the owners manual several times, and
> have found no
> mention of my problem.
> also, i really enjoy this amp and recommend it to others. it
> has really
> helped my signal alot on 80/160 dx!
> any ideas??
>
> thanks es 73's
>
> bill capps
> af4od
> auburn, alabama
> fists #4101
>
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
Duane Calvin, AC5AA
vacationing in Cincinnati for "Tall Stacks",
America's Steamboat Festival, 1999
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|