Hello Scott!
I have 20 TIC rings (with pots) in service here. Mine are TIC 1032.
Your report sounds like a POT problem (defective). It is 10 turns and 500
ohms and available at DXE
I suggest you replace the POT and calibrate to zero degrees.
73
Tim K3LR
-----Original Message-----
From: CQ-Contest [mailto:cq-contest-bounces+k3lr=k3lr.com@contesting.com] On
Behalf Of w5wz@w5wz.com
Sent: Monday, January 9, 2023 8:07 PM
To: cq-contest@contesting.com
Subject: [CQ-Contest] Issue with TicRing 1022D/E
Physically, the antenna appears to be pointed about 150 degrees. The
controller displays 60 degrees. Turn knob CCW to any position beyond 30
degrees and push start, nothing happens. However, with the knob at
about 35 degrees and any where CW to 180, a brief tap of START elicites
a sharp BUZZ (like an alarm sounder) from the controller. It also
appears to rotate the antenna CW; I quickly turn the know CCW to stop
rotation, because I don't want to over-rotate and put coax in a bind.
I don't see anything in my TicRing manual about an alarm buzzer, nor do
I see any resistances for troubleshooting from the ground. I suspect
others have encountered this before, and am hoping to get some hints
before retrieving the motor from the tower.
--Scott, W5WZ
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|