The "AM radio up close" test may or may not tell you whether the device
produces enough RFI to be detectable at HF. A better test is to listen
to your HF radio, using your normal antennas, as you switch the device
on and off. It's almost imperative to use a spectrum display with at
least a 100 kHz span, as the switching supplies in these devices
typically run at 20 kHz and up, generating harmonics. If your receiver
happens to be tuned between harmonics, you won't hear it, but it's
guaranteed to drift right to the frequency of that rare DX you're trying
to work.
I was successful in tracking down a noisy switching supply with a
portable HF receiver. After it warmed up, this source was quite stable,
I could tune a portable HF receiver to a harmonic on 20 meters, which I
could hear on the station receiver. I walked around the neighborhood
until I found the strongest signal, then went home and got my 135 MHz
tracker, with which I could hear it standing right in front of the
neighbor's house. In fact, it pointed to the right room in the house.
I went in with the portable 20 meter receiver and asked them to start
switching lights off. It was the power supply for the LED tapes in the
family room. I offered to pay half the cost of a replacement supply,
and all is well. (At least from those lights; there are many more noisy
switching supplies in the neighborhood.)
73,
Scott K9MA
On 10/19/2017 16:13, Mike Ritz wrote:
I have a variety, but the one that I have easiest access to for checking was marked as
"MaxLED by Maxlite, 800 lumens, 2700K, 9W". I could put the AM radio within a
few inches of the lamp and there was no noticeable noise. That said, this is a more
expensive dimmable LED bulb, and I did find out that the dimmer switch itself (the lamp
is from IKEA), puts out quite a bit of noise unless the LED lamp is driven to full
brightness. I guess this could be expected as it probably pulse width modulates the lamp
to provide the dimming.
Around my radio benches are pretty quiet, as all my supplies for 12V equipment
are transformer units, mostly from the local Goodwill store (generally $2.99
each!). A lot of hash is noticeable around the Comcast router in adjoining
room, but my question is; How far out does the noise have to go to be a
problem? If I only can detect the noise with my AM radio at 6 inches to 1 foot
or so from the object, is that quiet enough, or is ANY noise emitted to any
distance unacceptable? How far do we need to take it, and how much noise is
acceptable?
73;
Mike
W7VO
----- Original Message -----
From: "W3IDT Bob" <w3idt@comcast.net>
To: "Mike Ritz" <w7vo@comcast.net>
Sent: Thursday, October 19, 2017 9:29:29 AM
Subject: Re: [CQ-Contest] LED Lighting RFI
Mike,
You said, "Surprisingly, the LED bulbs I have in all my lighting
fixtures have been quiet."
Do you know what brand?
Thanks.
Bob, w3idt
--
Scott K9MA
k9ma@sdellington.us
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|