Andy, Thanks for this clarification. Understood.
I still think it is a slippery slope and a mistake, even for the assisted
category. Especially with more and more people calling for merger of
unassisted and assisted.
>From a practical standpoint, it would seem much more likely that competitive
>entries wanting to SO2R with clear reception would take advantage of a remote
>receiver up to 100km away than lot restricted entrants needing it just to get
>on and compete. But maybe I am wrong. Have you been able to collect any info
>on who is actually taking advantage of the rule?
73
Ed N1UR
From: Andy Blank [mailto:andyn2nt@gmail.com]
Sent: Monday, March 20, 2017 1:15 PM
To: sawyered
Cc: CQ-Contest Reflector
Subject: Re: [CQ-Contest] SSB & CW On Same Band
Hi Ed.
Just to clarify about the CQ 160 contest;
The option for remote receivers is available ONLY in SO Assisted category.
It is not permitted in Single Op or Multi Op.
It's inclusion was in direct response to the request of more than a few
participants.
Due to the unique nature of 160, and lot limitations; many have added that
capability.
They have high noise levels at the TX site.
This accommodation was made to mirror the same rule incorporated in the Stew
Perry contest.
Remote RX must be located within 100KM of the TX site.
There have been some abuses of this, but due to the tools we have now it is
easier to detect.
As always, we hope and expect all contestants to follow the rules.
73, Andy N2NT
Director CQ160 Contest
On Sun, Mar 19, 2017 at 12:50 PM, Ed Sawyer <sawyered@earthlink.net> wrote:
Some of the SO2R operators run 2 radios on one band and I believe MOST of
the mult-ops do.
I do here at N1UR. I use cross polarization (transmit vertically on 160 and
listen horizontally - and transmit horizontally on the other bands and
listen vertically). I also use tip to tip orientation and at least 300 ft
separation. Using Low Power, I had pretty much the noise floor to within
20khz on all bands - 10khz on CW.
With high power, the noise floor is lifted by probably 20dB across the band
but otherwise everything is totally readable to about 20 - 25khz from the
signal.
I run the 2nd receive signal always through the aux receive port and through
a front end protector.
It takes good engineering and the space to place things in the right part
and with separation. But its doable.
Hopefully such required engineering practice doesn't get killed by the
ability to operate remote receivers in the major contests. I was not happy
when that option was given in the 160 CQ WW contests. A bad decision in my
opinion.
73 N1UR
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|