Correction...
It has been brought to my attention that the rule says:
"... must record the transmitted and received audio as heard by the
operator for the duration of the contest operation"
For my station configuration, that is "interesting". Running SO2R, I
always have the CW sidetone and SSB TX Monitor muted. Thus, the operator
(me) doesn't hear any transmitted audio, and, therefore there is no
transmitted audio to be recorded.
73,
Steve, N2IC
On 03/05/2017 07:49 AM, Steve London wrote:
For the purposes of CQWW and WPX recording, your transmit audio is not
required. They want to hear what you heard.
73,
Steve, N2IC
On 03/04/2017 09:01 PM, Trent Sampson wrote:
All this recording talk has made me revisit the shack configuration.
After testing the FT2000 FT950 I can get the RX audio out of the
RECORD Jack on the rear panel but no transmit audio on any modes
The Manual(s) says to set monitor to on - but there is no difference -
Modes will be SSB RTTY and CW.
Has anyone successfully done this or do I need to try some other point?
My issue is the FT5000 rigs are at a remote site and really want to be
able to sort this out prior to the 4 hour round trip to the remote.
Thanks in advance.
Regards
Trent
VK4TS
PO Box 275
Mooloolaba 4557
0408497550
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|