With the N1MM works great in cw and ssb......
Alex www.yv5ssb.org.ve www.4m5dx.org www.yw5cq.org
----- Original Message -----
From: "K0HB " <k-zero-hb@earthlink.net>
To: "CQ-Contest" <CQ-Contest@contesting.com>; "MWA Reflector"
<mn-wireless-assn@yahoogroups.com>
Sent: Sunday, December 25, 2005 12:54 PM
Subject: [CQ-Contest] MFJ-434 Voice Keyer
> Santa left me a new MFJ-434 voice keyer to help with contesting vocals.
>
> Has anyone here used that with CT or other software, and built the
> interface shown in the MFJ literature?
>
> MFJ shows two resistors on each 'input' wire --- a 470-ohm at the computer
> end of the wire and a 1K in series with that on the circuit board at the
> gate of the switch transistor. What's the point of separating these
> series transistors? It requires hiding a glob of 470-ohm resistors inside
> the Dsub at the computer end of the cable. Why not just put single 1.5K
> resistor on the circuit board?
>
> 73, de Hans, K0HB
> --
>><{{{{*> http://www.home.earthlink.net/~k0hb
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
>
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|