Early in the contest I was called by K3JJG who nicely
advised me that my transmission was noisy. It was a
recurrence of the well known Icom PLL trimmer phase
noise problem (I think - I will fix it over the next
few days). I was able to swap rigs and Ed waited to
tell me all was OK. Sorry if I caused any problems to
other stations. Ed's help was greatly appreciated.
Later in the contest an unidentified station jumped on
top of a weak European I was trying to decode and said
I had major key clicks. This 'help' was not
appreciated, and I'm afraid I ignored it except to
stop using full break-in.
I don't think I have significant key clicks, but it's
very difficult to be certain. What I am sure about is
that the transmitter/amplifier/antenna switching is
properly sequenced - there is definitely no hot
switching. Listening to my own transmission with
suitable attenuation it appears clean. Various other
stations seemed to have no problem starting up a few
hundred Hz from my run frequency. Rigs are IC-765s.
I would however be grateful for critical reports
direct.
Thanks
73 Roger
VE3ZI
___________________________________________________________
Moving house? Beach bar in Thailand? New Wardrobe? Win £10k with Yahoo! Mail to
make your dream a reality.
Get Yahoo! Mail www.yahoo.co.uk/10k
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|