A few days ago someone was putting together a ferrite group order. I
accidentally erased the message before reading. Please copy me on it or send
me an email address for direct contact. Thanks Hank KF2O
>From aa0ob@skypoint.com (Greg Fields) Fri Oct 18 04:36:51 1996
From: aa0ob@skypoint.com (Greg Fields) (Greg Fields)
Subject: W9XT Card/Icom 751 config?
Message-ID: <m0vE5jv-0000rPC@mirage.skypoint.com>
Hello,
I writing this for Jeff, AA0SQ, who recently
purchased a W9XT card. We worked on it tonight and
can't get it to transmitt voice from a Heil HM-10
mic into a Icom 751. Could you take a minute to
look at our wiring diagram and tell us if we
are doing anything wrong? We seem to be able
to record using the DVRC S/W but, we get no
output when playing the memory. And when the
mic is keyed with the switch we get a terrible
noise, some sort of feed back with a low tone.
DB 25 pins Radio Side
23 Mic in, pin 1 of Icom 751
11 Mic Gnd, pin 7 of Icom 751
25 Mic out, pin 2 of Icom 751. 27 uF cap in line
13 Mic GND, pin 7 of Icom 751
14 PTT OUT, pin 5 of Icom 751
1 PTT GND, pin 6 of Icom 751
8 CW plug of Icom 751
9 CW plug of Icom 751
CW works O.K., and card seems to be behaving
correctly but, we are wrong with our wiring
somewhere. Any help you could give would
certainly be appreciated since CQWW phone
is almost here!
73,
Greg AA0OB for Jeff AA0SQ
Greg Fields AA0OB
aa0ob@skypoint.com
Minneapolis, Minnesota
U.S.A.
|