I copied the following from packet radio. Does anyone with a FT1000
remember opening up the radio and making this mod? I notice that JP3
is nothing more than a solder point through the board. This configuration
made me nervous about soldering with all those CMOS LSI devices in the
area.
73, Dave (KN2M)
OUT OF BAND TX MOD FT1000
-------------------------
1. REMOVE POWER AND ANT.
2. OPEN CASE LIKE EXPLAINED IN YOUR "OPERATING MANUAL".
3. LOCATE FOUR SCREWS ATTACHING FROUNT PANEL AND REMOVE THE TOP SCREWS.
LOOSEN THE BOTTOM SCREWS.
4. TILT FROUNT PANEL FORWARD.
5. ON THE LEFT SIDE OF THE RADIO, REMOVE THE PLUG FROM POWER SUPPLY TO
THE FROUNT PANEL. (GRAY AND WHITE WIRES.)
6. LOCATE THE JUMPER POSITION 3 ON CONTROL BOARD.
7. CHANGE THE JUMPER STATUS IN POSITION 3.
8. REASSEMBLE RADIO.
9. RESET CPU (see your OPERATING MANUAL).
73's de Phil, F1LOU @ ON7RC.BT.BEL.EU
|