Hi Ted.
Make sure you have your AUDIO supplied through the PACKET connector,
not PATCH + AF OUT.
When in USER mode, the default setting is LSB, but you would need to
re=program it to USB for FT8 in the menu 8-6:
Menu8-6
modePKT
disp offset0
RX PLL1450
RX CAR453.450
TX PLL1500
TX CAR453.400
RTTY offset0
EASY setoff
As far as I remember, early production original MPs did not allow TX Car
to be set below
456.300 Khz, but W5ERX assures that these values work fine:
Disp Offset = +2125
RX-PLL = +2210
RX-CAR = 452.790
TX-PLL = +2210
TX CAR = 452.790
Unfortunately, I don't have my FT1000MP here at the moment (it's in Zone
2 in the storage), but as far as I remember you may Enter (store)
settings in the USER mode by pressing and holding this button for 2+
seconds. You should refer to the manual.
In USER mode the MIC GAIN control still affects transmit audio level
(check your ALC display)), but MIC input is disabled.
Sorry, can't be of more help at this moment.
73, Yuri VE3DZ
On 2022-07-24 5:30 p.m., tboerkamp@cogeco.ca wrote:
Hello..I am having a problem getting my FT1000MP original to transmit signal
on FT8.
I am using WSJT-X and I am receiving signals fine. I have tried to set USER
settings on the radio
According to some posted lists but I cannot get the radio to save the
settings after I enter them.
Can someone please explain how to save these settings changes??
I have my connection from sound out on the pc to the packet jack on the
back.
Maybe someone has a list of their own parameters from menu 8-6 they can
share.
I have tried two different sets as I could not adjust the TX CAR down to
453.500 as requested ( mine stopped at 456.300)
Any help appreciated.
73 Ted Boerkamp VE3SS
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|