I picked up a quadra and an FT1000 MK-V. I wanted the Quadra to go with
my 5000MP and the 1000 as a back up.
So far I think I have the proper cable in the proper places and menu 172
enabled on the 5000MP.
When I turn on the 5000MP the Quadra powers up and goes through the self
check and gives me Protection ON, Voltage NORMAL, Bias Check, Temp
Normal, Maintenance Mode ON, Slave ON.
My problem is I can't get the Quadra to change bands. It stays on 50
MHz. I can set it to manual, press F-Set and key the exciter (with low
power) It goes through its cycle, but the band still doesn't change.
Any thoughts?
I'm a complete novice where the Quadra is concerned and am sticking
strictly to the procedures in the manual.
73
Roger (K8RI)
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|