We have a 920 at the club and all you need is a regular rs 232 cable like
you can buy at any computer store. I don't know what goes to what, but it's
the same cable as you would use on a tnc to the rig.
----- Original Message -----
From: "William Liporace - WC2L" <wc2l@wc2l.com>
To: "Silvio Martín LW9EOC" <lw9eoc@speedy.com.ar>; <yaesu@contesting.com>
Sent: Friday, September 07, 2007 22:48
Subject: Re: [Yaesu] CAT FT-920 Interface
I do not have the book in front of me....
I belive it is: 2 ->3 3 ->2 - 5 ->5
Will WC2L
----- Original Message -----
From: "Silvio Martín LW9EOC" <lw9eoc@speedy.com.ar>
To: <yaesu@contesting.com>
Sent: Friday, September 07, 2007 6:27 PM
Subject: [Yaesu] CAT FT-920 Interface
Hi to all, name here is Tim and callsign is LW9EOC also as LS1D on contest.
Anyone would like tell me how is the connection the CAT to FT920 ?
I need the pin between serial port (DB9) to radio.
I´ve used the pin 2 to 2 (RXD), 3 to 3 (TXD) and 5 to 5 (GND) but it´s not
found on N1MM. i´ve tried change the speed, bits and always on always on.
anyone could help me. thanks for advance. 73 de Tim LW9EOC/LS1D
lw9eoc@speedy.com.ar
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|