It sounds like the seller had a CW filter in one of the IFs that
was removed before he sold you the radio without resetting the
filter selection menu.
Without knowing what filters are still installed, check menu
5-2 (CW nor), 5-1 (8.2-2.0), 5-3 (8.2-250), 5-5 (455-2.0),
5-6 (455-500), and 5-7 (455-250). The factory "stock" settings
are: 5-2 = 8.2, and 5-1, 5-3, 5-5, 5-6, 5-7 = OFF.
Check pages 29, 101, 102 and 113 for more detail on the CW filters,
their installation, options and configuration.
Also check the Nor, Nar1, and Nar2 selectivity options for the
main receiver.
73,
... Joe, W4TV
> -----Original Message-----
> From: yaesu-bounces@contesting.com
> [mailto:yaesu-bounces@contesting.com] On Behalf Of Greg Richard
> Sent: Saturday, December 30, 2006 11:05 PM
> To: Yaesu@contesting.com
> Subject: [Yaesu] FT-1000 MK V Field
>
>
> I purchased a used FT-1000 MK V Field for a local and am
> having a problem with the main RX. It will not recieve
> signals when in the CW position on the main RX, no noise at
> all. When I tune the sub Rx to the same band, the band is
> full of signals. When I put the main RX in the SSB, FM,
> Packet mode, the main RX will work.
>
> Signals on the sub RX are much louder when the main Rx is on
> the same band. When I move the main RX to another band, the
> signal strength drops off on the sub RX.
>
> Before I take the radio back, is there a menu setting I need to check?
>
> Greg K4NO
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
>
>
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|