Frederico,
Check menu item 7-8 to see if you have the Sub-Receiver engaged. This
setting should be "ON" to see and use the second receiver.
It had been my impression that a new Mark V would have this setting "ON" by
default but perhaps that is not correct any longer.
73,
-Bill, WA9MXQ
----- Original Message -----
From: "Federico Zanini IK3UMT" <ik3umt@ir3ip.net>
To: <yaesu@contesting.com>
Sent: 03 February, 2006 07:03
Subject: [Yaesu] mark V sub receiver problem
> Hi All
> I own a new ft1000MP MK V
>
> I have this behaviour with sub vfo b :
>
> All bands are absolutely dead (no secondary s-meter reading neither any
> signal heard) except for 7 , 10 and 14 MHz bands
> where a constant S 9+10 noise is heard (like many electric discharges)
>
> Any idea ??
> Some macroscoping menu mistake (I hope) ????
>
> Thanks
> Federico
>
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|