----- Original Message -----
From: "Willem Braeckevelt" <on5jy@village.uunet.be>
To: "R March" <n7ua@ix.netcom.com>
Sent: Thursday, January 05, 2006 7:02 PM
Subject: Re: [Yaesu] FT1000D XMT Problem
> Hi Bob,>
> i had that problem also and i have replace 4 new diodes on SWR bridge
> circuit , one was broken and others varies values in conduction so bridge
> out of balance and power limiter in action !
> If this is the case easy to repair
>
> 73 Wim
>
> ON5JY Wim
> Halewijnstraat,17 8780- OOSTROZEBEKE
> Belgium
> ----- Original Message -----
> From: "R March" <n7ua@ix.netcom.com>
> To: <yaesu@contesting.com>
> Sent: Thursday, January 05, 2006 6:57 PM
> Subject: [Yaesu] FT1000D XMT Problem
>
>
>> My old faithful FT 1000D has developed a XMT intermittent. The power
>> drops
>> from normal to 1 watt. This happens very quickly, on and off, sounding
>> much
>> like a bad connection. It has hard to induce (in fact it seams to occur
>> only with rare DX, hi), but is somewhat sensitive to mechanical vibration.
>> No problem on RX. Has anyone else experienced a similar problem and found
>> a
>> fix? My first thought was relays, but outside of the LPF relays, their
>> really aren't any in the signal path, at least that I could find (?). This
>> happens on both SSB and CW. Any ideas are welcome.(Relays, pots,
>> connectors, grounds, ??) But I am especially looking for any known
>> failures that produce these results. Thanks, Bob
>>
>> _______________________________________________
>> Yaesu mailing list
>> Yaesu@contesting.com
>> http://lists.contesting.com/mailman/listinfo/yaesu
>
ON5JY Wim
Halewijnstraat,17 8780- OOSTROZEBEKE
Belgium
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|