I suppose you've check to see if you have selected antenna 2(or 1) or
the rx antenna with no antenna connected to those ports?
John N1JM
Patrick W7TMT wrote:
> Just picked up a new FT-1000MP Mark V Field and before I take it back to the
> dealer I thought I'd see if the knowledgeable folks on the list had any
> suggestions for this problem.
>
> Brand new out-of-the-box radio. No extra filters added yet (I have an order
> in the pipe-line to InRad). When I first turned the radio on the
> sub-receiver appeared to work as expected. After about a half hour of
> reading through the manual and looking at the various settings etc. and
> tuning around the bands checking out the receive functions the sub-receiver
> suddenly quit working. Never even put the radio into the transmit mode I was
> just listening to the receiver and trying out the various EDSP and filter
> settings. Audio is there and lots of background noise, in fact much more
> than in the main receiver, but no signals are received. Since then I have
> verified that VFO can be used to control the transmit freq. but the receiver
> is gone. I have already done a total CPU reset per the manual (twice) to no
> avail. Any ideas other than me boxing it up and taking it back. Fortunately
> the store is within driving distance (if you consider a couple of hours
> "within driving distance").
>
> Thanks for your assistance.
>
> 73,
>
> Patrick
> W7TMT
>
>
>
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
>
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|