For info, I have found a (cheap) way to do this - CAT data can be obtained
from the Mic socket if menu #59 is set to CAT, then linear switch and band
data can be obtained from the rear socket. Many thanks to those who replied
with suggestions. See http://www.k6xx.com/radio/ft857ser.pdf for solution.
73
Stewart
GM4AFF
-----Original Message-----
From: yaesu-bounces@contesting.com
[mailto:yaesu-bounces@contesting.com]On Behalf Of Stewart GM4AFF
Sent: 30 September 2005 23:03
To: yaesu@contesting.com
Subject: [Yaesu] FT-897 CAT, Linear and Band Data
Anyone got any info on how I might be able to use CAT, linear control and
band data outputs all at the same time on an FT-897D?
Stewart
GM4AFF
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|