Hi Gang:
I am having a problem with my FT900AT.
The bands affected are 160, 75/80 and 40 meter bands.
If you bring any of those bands up, after a couple of seconds the display
starts to blink on and off.
There is no noticeable function of the radio like, audio output or keying the
PTT with the microphone or CW key. You can however, tune the frequency with the
tuning knob.
I tried the reset to default for the radio. And still the same results.
If I tunen the radio in the GEN setting, all works fine till I tune down to 7.5
MHz., then the display starts blinking again, with the same results as with in
the 3 lower bands.
I am sure it is out of loop sync. in those bands or below 7.5 MHz.
Anyone have a fix for this condition?
Thanks in advance.
Bob, K9CGD
Longmont, Co.
303-702-5421
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|