Hi Javier:
I see this all the time with my Mark V to a Alpha 87A to Ten-Tec tuner
and out to the antenna via Array Solutions RatPak antenna switch. The
only thing I can figure is that there is some reactance in between the
amp and the Mark V that is not tuned out. Now, I don't use the tuner
in the Mark V to tune this out - Alpha advises against using any tuner
in front of it - but, boy, am I tempted !
73, Jamie
WB4YDL
On Dec 28, 2003, at 5:31 PM, jlopez@plasticosomega.com wrote:
Hi,
I just had been using my new Mark V for few hours and I found the
behavior shown below, wich I dont know if its normal.
The rig is feeding a Ten-Tec Centurion Amp after wich there is a
Ten-Tec antenna tuner between the amp and the antenna.
My antenna has 1.4 swr so the tuner is bypassed and with the amp in
standby mode there is no problem but if I operate the amp the swr
shown at the Mark V goes to 3 or 4 but the swr meter at the antenna
tuner in by-pass mode shows 1.4.
What could be happening???
Advice welcome,
73's de Javier
yv5mbx
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|