Operator's Manual (Page 7) shows pin 1 to be to the LEFT
of the "notch" when looking at the wiring (cable) side of
the PLUG. Pins appear to be numbered clockwise 1 through
5 with pin six being in the center of the "horseshoe"
Pin 1 is ground, pin 2 serial out, pin 3 serial in,
pin 4 PTT, pin 5 S/PO, pin 6 N/C.
I suspect one could confirm pin 1 by looking for zero
Ohms to ground.
73,
... Joe, K4IK
> -----Original Message-----
> From: yaesu-bounces@contesting.com
> [mailto:yaesu-bounces@contesting.com] On Behalf Of Barry N1EU
> Sent: Wednesday, December 17, 2003 8:06 PM
> To: yaesu@contesting.com
> Subject: [Yaesu] FT-1000 CAT connector pinouts
>
>
> I've searched without finding the answer and would sure
> appreciate help. If I'm looking at the male 6-pin DIN
> FT-1000 CAT connector (from the jack's perspective), is
> pin 1 to the left/CW or to the right/CCW from the ground
> nub? The service manual schematic fails to disclose the
> orientation.
>
> Thanks & Happy Holidays,
> Barry N1EU
>
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|