| To: | "Osten B Magnusson" <sm5dqc@algonet.se>, <Yaesu@contesting.com> |
|---|---|
| Subject: | RE: [Yaesu] FT-990 again... |
| From: | "Kjell W. Strom" <strom@lime.demon.nl> |
| Reply-to: | strom@lime.demon.nl |
| Date: | Fri, 12 Sep 2003 14:47:28 +0200 |
| List-post: | <mailto:yaesu@contesting.com> |
Hej Östen, How did you come across a Belgian version? I think that jumper JP5001 may be the solution. You will find it on the Control Unit, where it is connected to Pin 48 on the CPU Q5004. In the real world it is located next to the Filter Switch, refer to the photo at the lower left of page 46 of the Operating Manual. If there is a solder blob on JP5001, remove it and proceed to adjust the power like Thomas described. 73 Kjell PB3SM - SM6CPI _______________________________________________ Yaesu mailing list Yaesu@contesting.com http://lists.contesting.com/mailman/listinfo/yaesu |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Yaesu] Firmware version FT990, Berndt Josef Wulf |
|---|---|
| Next by Date: | [Yaesu] FT-840 Display Backlight intermitent, KP4JRS - Jose |
| Previous by Thread: | [Yaesu] FT-990 Power Output On 160, Thomas Giella KN4LF |
| Next by Thread: | [Yaesu] FT-902DM Counter Board, Mick |
| Indexes: | [Date] [Thread] [Top] [All Lists] |