He makes a good point. Does anyone else have
experience with neutralizing an FT-101B ??
Any comments? It sounds easy in the manual. Is it that easy?
On 28 Aug 2021 at 19:31, Firson Maryutenli wrote:
> Sorry,
> You need insulated screwdriver to trim that capacitor.
> Because 300 volt present on that circuit.
>
> Firson - YC0LZH
> ----- Original Message -----
> From: Firson Maryutenli <firson@indosat.net.id>
> To: <SGTOKIE@aol.com>; <yaesu@contesting.com>
> Sent: Saturday, August 28, 2021 7:24 PM
> Subject: Re: [Yaesu] ft-1o1b
>
>
> > I have same experience with FT-101ZD.
> > My opinion,
> > When you have normal output with others band, the problem not on
> > tube driver. It's need to trim the capacitor trimers below chasis on
> > that 101b, you should trim the capacitor to max output.
> >
> > Trim the capasitor related to 15 and 10 meter only, you should know
> > which one that should be trimed.
> >
> > Firson - YC0LZH
> > ----- Original Message -----
> > From: <SGTOKIE@aol.com>
> > To: <yaesu@contesting.com>
> > Sent: Saturday, August 30, 2003 3:10 PM
> > Subject: [Yaesu] ft-1o1b
> >
> >
> > > i recently purchased a 101b that had decreased output on 15 & 10m.
> > > the
> guy
> > said the driver may be getting bad.....if i replace just the driver
> > tube,
> do
> > i need to do any special realignment?........de kd5qwo. david howard
> > > _______________________________________________
> > > Yaesu mailing list
> > > Yaesu@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/yaesu
> >
>
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|