Yes, you need to unplug the cable from one socket and plug it into another
socket.
Dave - N8IT
On Fri, 12 Apr 2002, W.P.Van Horn wrote:
> I want to use my FT-100D with my VL-1000 amp.There is an instruction on page
> 19 of the FT-100D Operating Manual that says "When operating the FT-100D with
> the VL-1000 Solid State 1 KW Linear Amplifier, change the internal
> connections of the FT-100D as shown below." There is a sketch of the bottom
> side of the FT-100D showing a cable with two plugs and three sockets with an
> arrow going form one socket to another. I don't understand that instruction.
> Must I remove the bottom cover of the FT-100D to see the area referred to in
> the sketch?
|