Hello Markus,
You might want to remove the top cover off the MP and "wiggle" the jumpers
that run from the antenna switching circuit board to the two SO-239
connectors on the back. See if you can cause the problem to occur. Also
check for a cold solder joints on the SO-239s and on the switching board.
Lightly tapping on the relays on the switching circuit board may also narrow
down your search.
GL and HNY!
73,
John W0DC
----- Original Message -----
From: "Dr. Markus Dornach" <dornach@panet.de>
To: <yaesu@contesting.com>
Sent: Sunday, December 30, 2001 20:55
Subject: [Yaesu] FT-1000 MP problem
> Hello friends,
>
> my FT 1000 MP has developed a strange problem - after a few minutes or a
> few hours (depending on the room temperature) the TX and RX fails...as
> if there is no ANT connected...if you switch it off, wait a few minutes
> and switch it on again the failure has gone..and the same game starts
> again...you can cure the problem also by simply opening the window so
> that cold air can enter the rig...so i suppose that it is a
> temperature-related problem..maybe a relay? it is annoying because it is
> no permanent problem but always there...has anyone of you a hint for me?
>
> btw: the FT 1000MP is 3 years old..manufacturing date Oct 1998
>
> best 73 de Markus, DL9RCF
>
> ARRL - GERMAN DX FOUNDATION - DARC - HAWAII DX Association
>
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
|