Jay, the manual doesn't describe it because the rig came equipped with a
Yaesu filter in that position and therefore wasn't viewed as an installable
internal accessory. You will be replacing the Yaesu filter marked
XF8.2M-251-01. With the rig upside down and front panel toward the front,
it is the filter furthest toward the back and to the left. No diode to clip
because it came equipped with the filter from the factory.
GL/73,
Barry N1EU
www.albany.net/~bg
>From: "Jay Kesterson" <k0gu@hotmail.com>
>To: yaesu@contesting.com
>Subject: [Yaesu] FT-1000D 250 Hz 8215 MHz filter Installation??
To: <yaesu@contesting.com>
>Date: Wed, 21 Nov 2001 23:59:58
>
>Hi all,
>
> I purchased an INRAD 250 Hz filter for the 8215 MHz IF in my FT-1000D.
>The manual goes into detail on the 455 kHz IF filters but didn't notice
>anything on the second IF filters (except can see them in the picture
>showing the 455 filters). Think it will be obvious where to install the
>filter. Is there anything else required like a diode that needs to be cut
>(like on the 455 filters), etc??
>
>Thanks,
>
>73, Jay K0GU
>
>_________________________________________________________________
>Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp
>
>_______________________________________________
>Yaesu mailing list
>Yaesu@contesting.com
>http://lists.contesting.com/mailman/listinfo/yaesu
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp
|