Pete;
If you plan on ONLY using this radio on QRP, then I suggest that
you place a 50 ohm pad on the output of the PA board. A 10DB
pad will drop it down to .3 watt. Below 3 watts, the PA board
will put out too much noise otherwise. Good luck
Dave WA0ZZG
On Mon, 21 Feb 2000, Pete (N9SSA) wrote:
>
> Hello!
>
> I have a Yaesu FT-900/AT, that will run a minimum of 3 watts QRP. I would
> like to operate the transceiver between 0 and 3 watts, or at least 1/2 and
> 3 watts.
>
> Does anyone know the best way to do this on the FT-900/AT?
>
> Thanks for your help!
>
>
> N9SSA - Pete Hoffswell
> Holland, MI - EN62wt - 42.79N 86.15W
> n9ssa@arrl.net http://www.qsl.net/n9ssa
> QRP-L #2109
>
>
> --
> FAQ on WWW: http://www.qsl.net/k7on/yaesu.html
> Submissions: yaesu@contesting.com
> Administrative requests: yaesu-REQUEST@contesting.com
> Problems: owner-yaesu@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
--
FAQ on WWW: http://www.qsl.net/k7on/yaesu.html
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: owner-yaesu@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|