A friend is having problems obtaining full power output on cw. Listed
below are the things he has tried and a statement of condition. Any one
have ideas on the source of the problem? The friend is WA8SDA,
fmauser@juno.com.
Fan is OK......let me give you the results of testing I have done.
Problem seems to be only in cw mode and power starts to dwindle after
45 minutes of being on and just in a receive mode. With the xmtr
being keyed every 15 minutes for a check of output power(xmtr would
only be on for a couple of seconds to read the meter.) After 1 hour
and 5 minutes output power has dropped to 5 watts out, and then slowly
starts to rise to about 60-70 watts out after about 2 hours of on
time. It then stays at this 70 watts out or so unless I hold the key
down for a few seconds and the power will drop to about 60 watts and
remain there. At any time during this testing if the ssb or fm mode
is enabled, I will always have ~110 watts out, not so with cw.
Test conditions:
All testing into a Heathkit Cantenna
Results are the same on all bands, except I did not test WARC bands
Makes no difference if antenna tuner is in or out of line
RF power and mike gain set to max
Meter always shows 13.5 volts dc
Icc will diminish as power falls(only for cw, ssb and fm OK)
Fan will run initially in cw setting since it has good output, but as
power drops fan doesn't come on......not really needed I guess.
Comments? Questions? Input? Appreciated.
Tom, W1TO
--
FAQ on WWW: http://www.qsl.net/k7on/yaesu.html
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: owner-yaesu@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|