Well so far I've had time to try the following suggestions and ideas:
1. Turn off the 2 meter rig. Did this and the problem went away,
but
of course so did my packet connection <BG>
2. Ground to case of the rotor control. Tried many different
points
and no change.
3. Checked the SWR on the 2 meter rig. SWR is below 1.1 to 1.
4. Dropped an e-mail to Yaesu tech support. No answer yet!
I'll keep trying things and let everyone know.
73 - Ted - W8TTS
Ted Sarah wrote:
> I just installed a G-800S rotator and have an interesting problem. When
> it's on every once in awhile the pointer moves a little, about 5
> degrees, and then goes back to the correct spot. This would happen
> every minute or so. I couldn't figure it out, checked the wiring, etc.
> and every thing was fine. Then I happened to note that it happened
> every time my 2M packet radio, Yaesu FT-8000, transmitted. Go figure a
> rotator with an RF problem. Any ideas on how to correct this other than
> the usual torid cores on the cable?
>
> 73 - Ted - W8TTS
>
> --
> FAQ on WWW: http://www.qsl.net/k7on/yaesu.html
> Submissions: yaesu@contesting.com
> Administrative requests: yaesu-REQUEST@contesting.com
> Problems: owner-yaesu@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.qsl.net/k7on/yaesu.html
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: owner-yaesu@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|