Hi Folks,
I have successfully located the resistors to provide variable 'RF Gain
and
Noise Blanking". I also noticed what I think are two unused pins on the
"Band
Data" jack. Pins 1 and 2 appear to not be wired to the RF control
board. The
show infinite resistance when I check them with my ohm meter. Can anyone
verifity that the operations manual is in error when it claims that pin
1 is 13 volts and pin 2 is TX Ground?
I've asked Yaesu but they won't be around to answer till next week.
Thanks,
dave
--
FAQ on WWW: http://www.qsl.net/k7on/yaesu.html
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: owner-yaesu@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|