Hello
I just purchased new FT1000MP and I was about to connect LT2S transverter
from SSB electronics to MP's TRV jack, but the manual says that MP gives
only -6dBm from the TRV jack. Is that correct or typo? That's like 250uW
which isn't enough for any kind of transverter. If it's correct can I adjust
it higher to give at least 1mW or 0dBm which would be enough for LT2S?
Thanks in advance. I will appreciate all help in this matter.
73 de Juha OH6KSR
--
FAQ on WWW: http://www.qsl.net/k7on/yaesu.html
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: owner-yaesu@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|