[Yaesu] FT767 70CM module - select 10 MHz range?

[robin@g3tkf.demon.co.uk (Robin Thompson)]

I've recently aquired an FT767GX - borrowed from the local club while my
FT1000 is being repaired(hope it's not away too long!!). On 70cms the
display reads 10Mhz HIGH of the actual frequency...without the relevant
part of the manual HOW do I get it to read the correct frequency - or
even toggle between them as Dave WB0GAZ asks ??
In article <199809132321.QAA06895@netcom7.netcom.com>, David Feldman
<dgf@netcom.com> writes
>
>Can the FT767's 70CM module be toggled between the two applicable
>10 MHz ranges, or is it fixed to one or the other?
>73 Dave WB0GAZ dgf@netcom.com
>
>--
>FAQ on WWW:               http://www.qsl.net/k7on/yaesu.html
>Submissions:              yaesu@contesting.com
>Administrative requests:  yaesu-REQUEST@contesting.com
>Problems:                 owner-yaesu@contesting.com
>Search:                   http://www.contesting.com/km9p/search.htm
>

G3TKF
Robin Thompson
City of Bath
U.K.

--
FAQ on WWW:               http://www.qsl.net/k7on/yaesu.html
Submissions:              yaesu@contesting.com
Administrative requests:  yaesu-REQUEST@contesting.com
Problems:                 owner-yaesu@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm