This is a multi-part message in MIME format.
--part0_894118889_boundary
Content-ID: <0_894118889@inet_out.mail.aol.com.1>
Content-type: text/plain; charset=US-ASCII
--part0_894118889_boundary
Content-ID: <0_894118889@inet_out.mail.aol.com.2>
Content-type: message/rfc822
Content-transfer-encoding: 7bit
Content-disposition: inline
From: KA2YKC <KA2YKC@aol.com>
Return-path: <KA2YKC@aol.com>
To: silver@ax.apc.org
Subject: Re: [Yaesu] problem with the FT101E
To: <yaesu@contesting.com>
Date: Sat, 2 May 1998 10:20:35 EDT
Organization: AOL (http://www.aol.com)
Mime-Version: 1.0
Content-type: text/plain; charset=US-ASCII
Content-transfer-encoding: 7bit
In a message dated 98-05-02 10:06:11 EDT, you write:
<< My FT101E is transmitting in one frequency and receiving in another, about
0.1 Khz of difference. Not much but enough to bother me!
Any tips to fix this problem?
73,
Carlos
PT2HO
PY1CAS >>
There isa pot labeled "zero" on the regulator board in the rear center of the
radio, accesible from under the top cover. Simply use a freq counter to
measure the VFO output freq at the ext. vfo jack, and dial up a given freq in
receive mode. Then ket the mike with the power set low (as to avoid the RF
falsing the counter), set the "zero" pot to get the same freq reading on tx as
you had on Rx. THis is a common problem as this pot is extremely touchy and
changes value slightly with age.
Keep that classic humming !
73 Eric
FT101 collector .
KK2ED
--part0_894118889_boundary--
--
FAQ on WWW: http://www.qsl.net/k7on/yaesu.html
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: owner-yaesu@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|