Could someone help me translate the pin-out requirements for the
Timewave DSP-599zx?
The DIN jack on the back of the DSP needs "PTT In" and "PTT Out"
signals, according to the Timewave manual. The simpler set-up in their
manual, using only a phono plug, picks up a "PTT Out" signal from the
back of the radio.
My FT-990 manual shows several jacks on the back of the rig with a "PTT"
pin-out:
Pin 6 on Remote (not currently in use)
Pin 3 on DVS-2 (not currently in use)
Pin 3 on RTTY (in use with my PK232-MBX)
Pin 3 on Packet (in use with my PK232-MBX)
I don't understand the In/Out differentiation for the PTT signal
apparently required by Timewave. Can I simply use any of the "PTT" pins
shown in Yaesu's manual?
Any advice and recommendations would be appreciated.
Bill W2ET
--
FAQ on WWW: http://www.qsl.net/k7on/yaesu.html
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: owner-yaesu@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|