Anybody had a problem getting the correct frequency from the 1000MP into
LogWindows v3.0?
Set Frequency command works fine, but only seems to interact with VFO B.
Mode changes register properly. Example returned frequency readings seem to
correspond with VFO A settings and are 0.443.75 for 7.100.00 and 0.450.00
for 7.200.00 Mhz, etc. On 20 meters, 0.887.50 is returned for 14.200.00.
Any suggestions? I'm off to check some other rig control programs for
similar problems.
73,
Brad - K9BZ
--
FAQ on WWW: http://www.qsl.net/k7on/yaesu.html
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: owner-yaesu@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|