Following the DVS-2 output distortion mod I sent it to
the reflector, here the dis-assembly instructions:
1. The sole philips-screw closing the DVS-2 box is placed under
the right-upper side rubber foot ,near the control cable.
2. After opening this screw, use a large flat screwdriver to open the
plastic enclosure. Apply resonable force on every side of the
enclosure. Pay attention to reset button and to lower side
opening to prevent mechanical and/or estethical damages.
3. They are two cards inside: the upper PCB ( contents the keys ,
leds and the switch; is fixed to front panel by screws ); the second
is the component PCB with lots of SMDs. The connection between
the two boards is done by a small unlocked SMD connector. Extract
very carefully the bottom PCB from this connector and do the changes.
4. If the DVS-2 unit is in use more than one year, replace the 3V
lithium battery model SONY CR-2032 ( with soldered pins for PCB).
The first models have some leakage and the back-up battery is being
exhausted in less than one year. No need to replace the battery if
the voltage measured is more than 2.8v.
5. To re-assembly the unit, insert carefully the botom card into the
upper card connector. Insert very carefully the bottom plastic
enclosure into the front panel , paying attention to the control
cable
and to small reset button. Then, check for fully closure of the box
and put inside the upper hole the philips-screw. Apply the sticky
rubber foot over the screw head and that's all.
73 de Morel, 4X1AD
--
FAQ on WWW: http://www.qsl.net/k7on/yaesu.html
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: owner-yaesu@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|