Hi, all.
I was using my FT-900AT at the weekend, I had programmed Shannon Volmet into
memory 1 (3.413 USB). I then pressed the power off button, and the rig switched
off. However, when I pressed power on, the display came up flashing on and off,
with about a 1/2 second interval, with no audio coming from the spaeker. I
cycled power and it was fine again, except that memory 1 reverted to it's
default setting (The rest of the memories are fine).
This behaviour only occurred once, but is not documented in the manual.
Has anyone else ever experienced an FT-900AT coming up with the display
flashing on and off ?!
Any help appreciated,
Martin.
--------------------------------------------------------------------------
Martin A. Gillen, CHAS (HM50) -=( M.Gillen@nortel.co.uk )=-
Advanced Technology Centre (HAL02) Building T Floor 2 West Wing Bay 46
Nortel Technologies Desk/voicemail: +44(0) 1279 402819
London Road, Harlow Site Reception: +44(0) 1279 429531
Essex, England, CM17 9NA. Dept. HM50 Fax: +44(0) 1279 402885
--------------------------------------------------------------------------
--
FAQ on WWW: http://www.primenet.com/~ke7gh/yaesu.html
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: owner-yaesu@contesting.com
Sponsored by: Akorn Access, Inc. & N4VJ / K4AAA
|