Thanks Tyler,
I loaded the COMTSR with the following command line:
"COMTSR1 -B4800 -N82" But still get "Yaesu radio timeout".
I also note that the COMTSR goes back to the default values each time I
try to load it, even after changing it.
Hmm.?
-Larry WZ4F
On Wed, 9 Oct 1996, Tyler Stewart wrote:
> No tricks. Just make sure your COMTSR is loaded for 4800 and 8n2 for that
> COM port. It should work. One other thing is to try a hard reboot and see
> if it starts up (reboot the computer not the radio!, and hit the button, not
> control/alt/delete)
>
> 73, Tyler
>
> >
> >I'm sure I'm overlooking something simple...
> >
> >Been trying to get CT 9.27 to interface with new FT-1000MP, but keep
> >getting "Yaesu radio timeout" at the bottom of the screen.
> >
> >Suggestions?
> >
> >-Larry WZ4F
> >
> >--
> >FAQ on WWW: http://www.contesting.com/yaesufaq.html
> >Submissions: yaesu@contesting.com
> >Administrative requests: yaesu-REQUEST@contesting.com
> >Problems: ke7gh@contesting.com
> >Sponsored by: Akorn Access, Inc & KM9P
> >
> ---------------------------------------------------------------------------
> | Stewart Communications - 301-253-5256 - kf3p@cais.com |
> | "Get the Best for Less!" |
> | Authorized Dealer: Standard Communications Land Mobile and Marine Radio |
> | Industrial Communications Engineers (ICE) and PAR Electronics |
> ---------------------------------------------------------------------------
>
>
--
FAQ on WWW: http://www.contesting.com/yaesufaq.html
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: ke7gh@contesting.com
Sponsored by: Akorn Access, Inc & KM9P
|