> Date: Sat, 25 Feb 2023 08:24:58 -0800
> From: "Bob Wolbert, K6XX" <k6xx@k6xx.com>
> Subject: [WriteLog] Learning WL: INI Mysteries no longer as mysterious
> 2. K3 or K4 DVR Message kill. Once a DVR message starts, it plays to
> completion: ESC won't stop it. How can this be fixed? Note that pressing
> the footswitch causes the rig itself to halt the message.
Hi Bob,
I wrote up a description for using the Elecraft DVRs in Writelog a few years
back, mostly repeating information that N6EE had posted earlier.
http://lists.contesting.com/_writelog/2016-11/msg00063.html
The way to enable ESC interrupts of the DVR playback is:
In Setup/Ports set the CommPTT to Yes for the K3(s). This will enable the ESC
key to be used for interrupting messages. Also set the DVK Type to None.
If you're in a mixed mode contest using VOX for CW keying then switching from
SSB to CW may cause occasional stuttering on CW unless the Setup/Ports PTT is
turned off for that radio while using CW. Or PTT can be used for CW instead of
VOX to avoid the stuttering.
73,
-Mike, N7MH
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|