Thanks Kevin. You did just remind me that I've been using the TS-2000 for rig
control and not the native Flex driver. The reason is that I've never been
able to get the Flex to work properly in SO2R using Flex 6000 for rig control.
It's been working perfectly for several years using the TS-2000 for rig control.
I'll make sure I have the current Flex driver installed and, if so, will try it
again but this time using Flex 6000 for rig control.
BobW1RH
On Tuesday, February 15, 2022, 09:41:38 AM PST, Kevin Rowett
<kevin@rowett.org> wrote:
Bob,
I’ve not experienced this behavior.
There is a recent update to the WL flex rig driver (the separate file/DLL to be
installed).
73, K6TD
> On Feb 15, 2022, at 9:38 AM, Robert Hess via WriteLog
> <writelog@contesting.com> wrote:
>
> I didn't get any response to this question, which appears to relate to just
> Flex owners who use Writelog.
> I took a few moments out of the CQ WPX RTTY contest and switched to N1MM.
> When I clicked on a spot, the Flex remained in RTTY mode. Doing same in
> Writelog has the Flex going to DigiU mode.
> During the contest, I uninstalled the latest version of Writelog and went
> back to V12.60 since there appears to have been a bug fix in 12.61 that might
> have caused my problem. For a short amount of time, this appeared to have
> worked but then reverted back to changing modes from RTTY to DigU when I
> clicked on a spot.
> Any suggestions will be appreciated. This problem does seem to have begun
> around the point where I installed newer versions....around 12.61.
> BobW1RH
> ----- Forwarded Message ----- From: Robert Hess via WriteLog
><writelog@contesting.com>To: writelog@contesting.com
><writelog@contesting.com>Sent: Friday, February 11, 2022, 03:04:24 PM
>PSTSubject: [WriteLog] RTTY Band Map Spots
> Been meaning to post this question for some time and always forget until the
> next RTTY contest.
> Using Writelog with a Flex, when I click on a spot in the band map, the radio
> goes into Digital mode, as in FT8. In the Flex modes list, there is Digital
> Upper, Digital Lower, and RTTY. Click on a RTTY spot in the Writelog Band
> map and it sends the Flex to that frequency but also changes the Flex to
> Digital-Upper. Any idea how to fix this so the Flex stays in RTTY mode?
> BobW1RH
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|