You need to start by troubleshooting the rig communication. Everything else
is a symptom of that.
Check the ports and make sure you have the right radio on the right port
with the right baud rate.
> -----Original Message-----
> From: WriteLog <writelog-bounces@contesting.com> On Behalf Of James Brown
> Sent: Saturday, November 17, 2018 9:12 PM
> To: writelog@contesting.com
> Subject: [WriteLog] Problems with 12.34K2
>
> Fired up the new version for Sweepstakes.
>
> Have all sorts of problems.
>
> -will not recognize the rig. says "no rig"
>
> -there is a red B after each sequence number entry in the log
>
> -an entry in the QSO entry box no longer self-deletes when tuning away
> from the frequency
>
> -the band map disappears after coming out of the setup ports screen
>
>
> Tried reinstalling. No luck
>
> Tried rebooting PC. No luck
>
> Read something about going back to the last "full" version install, then
> trying to reinstall 12.34K2 Do not know exactly what that means, and not
> sure what the last "full" version was.
>
> Have been using Writelog for many years and never had problems like this.
>
> Suggestions?
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|