I've done a little more testing this morning. Not sure why this would
cause the problem but it 'appears' that using %C in a canned message is
causing the Flex 6700 to mute, actually it's turning the volume down to
zero.
If I manually send the call sign with my paddle then send a canned F-key
message with the exchange the volume would not change.
It would only go to zero when I used %C in a canned F-Key message.
Rich - N5ZC
-------- Forwarded Message --------
Subject: Flex 6700 Muting after sending an exchange
Date: Fri, 19 Feb 2016 18:27:55 -0600
From: Richard Thorne <rthorne@rthorne.net>
To: Writelog <Writelog@contesting.com>
I'm not sure what's causing this. I'm a new Flex 6700 user so hopefully
this is a setting issue.
If I send a cq via F11, enter a call sign then hit F10 to send the
exchange the volume on the Flex 6700 goes to zero. The insert key
causes the same problem.
Any ideas?
Rich - N5ZC
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|