Thank you Wayne. I won't upgrade my Flex 6300 until after the RTTY contest
this weekend.
I will let you know if this solves my problem with running RTTY Split.
Joe K0BX
#1 Honor Roll Mixed
Honor Roll RTTY
Honor Roll 20 Meters
Honor Roll Phone
5BDXCC Plus 30,17,12
5BWAS
Stop the insanity!
Please do not add me to any distribution lists (Joke, Stories or Junk)
without my permission.
On Thu, Feb 11, 2016 at 6:59 PM, Wayne, W5XD <w5xd@writelog.com> wrote:
> > But now Flex has come out with a new version of the software V1.6.xx and
> > has changed the way DAX works and WLFlex Driver doesn't work with it.
> With
> > this weekend WPX I do not want to upgrade. But has anyone gotten this to
> > work?
> "doesn't work with it" is a little too strong a statement. It doesn't
> work the way it did with SmartSDR 1.5. But SmartSDR 1.6 has some
> improvements you probably want to use.
>
> The SmartSDR 1.6.xx from Flex added some capability that probably
> obsoletes the DAX replacement in the WriteLog Flex Drive. I say
> "probably" because I haven't had time to do the detailed performance
> measurements required to check the latency. But I can tell just by
> looking at the new Flex DAX control panel that they redesigned it such
> that RTTY split mode AFSK should work just fine with the 1.6.xx DAX
> Control panel while WriteLog's DAX replacement is simply turned OFF.
> Here is what I recommend:
>
> 1. In WriteLog, turn OFF its DAX Audio settings. Specifically, right
> click its Front Panel, and turn OFF all 4 settings under RX Audio DAX
> and TX Audio DAX. (This recommendation is opposite of what I recommend
> for SmartSDR V1.5) This turns OFF WriteLog replacement DAX
> feature--which doesn't work with SmartSDR 1.6 anyway.
> 2. Run the SmartSDR version 1.6 DAX Control panel. (This is the opposite
> of what I recommend for SmartSDR version 1.5--in the old version, I
> recommend leaving their DAX Control panel off.)
> 3. In the SmartSDR DAX control panel, turn ON the TX stream, and as many
> of the RX streams as you are going to use.
>
> Notice that with SmartSDR 1.6, the Windows audio device for your AFSK
> output is now named "DAX Audio TX" and it has no channel number now.
>
> When I get around to measuring the latency using the SmartSDR 1.6 DAX
> Control panel, I will decide whether to upgrade the WriteLog Flex driver
> to comply with their v1.6 API and replace their DAX with WL's lower
> latency version. Or (I hope!) instead simply recommend to Flex +
> WriteLog users not to use the WriteLog DAX for RX and TX.
>
> Note that the IQ channel is different! I recommend you leave it ON in
> WriteLog regardless of SmartSDR version, and you'll get your spectrum
> displayed on your Band Maps.
>
> Wayne
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|