Thanks for the reply Gary. I have the entire band defined to CW and has always
been that way.
Whatever was causing the problem stopped. I went straight from the BARTG Sprint
log to the CQ 160 log without shutting down and this
must have caused the problem. It stopped shortly after posted the message.
73, Don AA5AU
-----Original Message-----
From: WriteLog [mailto:writelog-bounces@contesting.com] On Behalf Of Gary AL9A
Sent: Saturday, January 24, 2015 11:09 PM
To: writelog@contesting.com
Subject: Re: [WriteLog] CQ 160 spots changing radio to RTTY mode
Don,
Go to Bands/Show Bands... Do you have the entire range from 1800 - 2000 kHz
defined as CW? Also check the Band Map. Do you have a
segment there defined as RTTY? If so a click on a spot there may change the
rig to RTTY.
73,
Gary AL9A
-----Original Message-----
From: Don Hill AA5AU
Sent: January 24, 2015 6:36 PM
To: writelog@contesting.com
Subject: [WriteLog] CQ 160 spots changing radio to RTTY mode
Many of the spots I'm clicking on in the CQ 160M module are changing my radio
to RTTY mode while others are not. I cannot figure out
why.
Any ideas?
73, Don AA5AU
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2015.0.5645 / Virus Database: 4273/8987 - Release Date: 01/24/15
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|