Mike,
In the Rttyrite window click on Port and then move your cursor to More...
just below the COM8 choice. Another list of COM ports up to COM16 will open
for you to select from. I am running V11.23L, but the change to add more
ports was made quite a while ago so your version may have it. If not, time
to upgrade.
73,
Gary AL9A
-----Original Message-----
From: Mike Streeter via WriteLog
Sent: January 10, 2015 6:42 AM
To: WriteLog Reflector
Subject: [WriteLog] Fw: MMTTY, Navigator and Writelog.
Subject: MMTTY, Navigator and Writelog.
I have read as much as I can but have not been able to find any information
on this specific matter. I am in process of setting up an SO2R station. My
original station has operated for quite a few years using an Icom 746,
Navigator and Writelog with the MMTTY plug in. I recently acquired an
Elecraft K3 and have moved the Navigator and Writelog over to it. That
setup is working well.Now, I have purchased a second Navigator from
Timewave, and they have set it up to operate on a second set of Com ports. I
have it connected up to my second radio, the Icom 746. The original
Navigator is on Com ports 3 through 8. The new Navigator is on Com ports 12
through 17. My original intention was to use a single PC but I can use a
second PC if I cannot get everything to work on one PC.I have set up the
second Navigator with the Icom using MMTTY stand alone and it works just
fine. (uses Com 15 for ptt). The problem occurs when I have Writelog with
MMTTY and the plug in loaded. There are then have 3 screens, the Writelog
log entry, the RTTY control panel and the Rttyrite screen. The ports setup
on the Writelog entry screen is no problem, it can accept up to 16 ports (I
don't need to use Com17), but on the Rttyrite screen the port setup allows
for only 8 ports, which means I cannot set a port for the Navigator and
therefore cannot use Writelog with the MMTTY plug in. Is there any way that
Writelog can be configured to increase the number of ports on the Rttyrite
screen? It seems odd that MMTTY stand alone can accept up to 16 ports,
Writelog can accept 16 ports but the Rttyrite screen can only use up to 8
ports.I am using MMTTY version 1.68A and Writelog version 10.73D. Do I need
a later version of Writelog that allows for 16 ports in Rttyrite?
Mike, WM5DX.
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|