Now that the RTTY Roundup is over, maybe some of the Flex-6xxx serial of
transceiver folks can help me with this.
I got a new Flex-6300 for Christmas, fine rig, but the people at Flex made
the DigL Mode with a center frequency of 1500HZ instead of the more popular
2125HZ for RTTY.
So I set the MMTTY Plug-in Wiitelog to low tones, 1445HZ with NET on. Now
I can use the Narrow filters, so far so good.
But if I try to use the BANDMAP or PACKET Spot windows to click on a
station, it sends me to the carrier frequency instead of the Mark tone of
the RTTY station I am trying to get.
So after reading the Writelog manual I found a INI file command that should
solve me problem in Writelog:
COM7_DIGITAL_OFFSET_HZ= -2125 Where COM7 is my CAT port and the offset is
-2125 which should put me right on the money?
Well clicking on a station does qsy me from the dial frequency to 2125
below it
Writelog now shows 14080 and my Flex shows 14082.125
BUT for some reason the station I am clicking on is always about 700HZ
below Writelog Frequency? Somewhere my math is off, either I have to
account for the 1500HZ Flex offset or the CW offset?
Any help would be appreciated.
Joe K0BX
Below is the paragraph from the Writelog manual:
*In some station setups for digital modes only, the rig reports TX/RX
frequencies offset from the center frequency of the on-the-air
transmission. (This is particularly likely in an AFSK setup.) The two INI
entries below cause WriteLog to offset the TX/RX frequencies it uses
compared to what the rig uses. With a second rig set to CW and listening to
your digital mode transmitted signal, its received frequency is the
on-the-air transmitted frequency. Note your transmitting rig's frequency
and subtract it from the on-the-air frequency. This result, including any
negative sign, becomes the COM_n_DIGITAL_OFFSET_HZ. WriteLog only applies
these offsets if the rig reports a digital mode, or if the LsbIsFsk is
option is set and the rig is in LSB mode. The n value corresponds to the
COM port number that is used to connect to the rig. *
COM*n*_DIGITAL_OFFSET_HZ=0
--
#1 Honor Roll Mixed
Honor Roll RTTY
5BWAS
Stop the insanity!
Please do not add me to any distribution lists (Joke, Stories or Junk)
without my permission.
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|