That's how I've always set it (CW PTT = NO)
Changing that parameter makes no difference. It just keeps transmitting....
Could I have set something incorrectly in the MK2 router?
73,
Eric W3DQ
---------------------------------------
Date: Sun, 07 Dec 2014 22:23:12 -0500
From: "Joe Subich, W4TV" <lists@subich.com>
To: writelog@contesting.com
Subject: Re: [WriteLog] WL/MK2 TX hang-up using MTTY
Make sure Writelog is *not* using "COM PTT" (PTT commands on the serial
port) as several rigs appear to have a subtle race condition between PTT
via CAT commands and hardware PTT.
My suspicion is that the rigs in question mask changes on the PTT input
while processing CAT PTT commands but ignore a CAT PTT off if the PTT
input is asserted ... then when unmasking the PTT input the transition
has been missed. I've never seen the issue (or heard reports of it)
in systems where COM PTT (or equivalent software PTT) has been disabled.
73,
... Joe, W4TV
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|