Joe,
I found something in the Help file, but need help understanding what it
means or how it is supposed to work. From the section Entry Object, the
last entry at the bottom of the page says:
long SendCustomRigCommand(string cmd)
If the rig driver for this Entry Window supports custom rig commands, send
the string to the rig serial port. Returns:
0 on success.
1 if there the Entry is set for Manual frequency entry.
-2 if the rig driver does not support sending custom commands.
This sounds like something a C++ programmer could access, not us mere
mortals!
73,
Gary AL9A
-----Original Message-----
From: joeduerbusch
Sent: September 18, 2014 2:00 PM
To: writelog@contesting.com
Subject: [WriteLog] Add SendCustomRigCommand to automation interface???
Looking at the new additions to WL, I see "Add SendCustomRigCommand to
automation interface"?
I did a search of the help file but did not find anything.
Where should I look?
Joe K0BX
--
#1 Honor Roll Mixed
Honor Roll RTTY
5BWAS
Stop the insanity!
Please do not add me to any distribution lists (Joke, Stories or Junk)
without my permission.
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|