Just prior to the CQWW 160-Meter CW Contest, I upgraded the PJ2T computers from
v11.14 to v11.18c.
At the beginning of the contest, we discovered that pressing the 'Ins" key did
not send the callsign and report we expected (in message F10), but instead was
sending the message in 'F2'. Likewise when 'Enter sends exchg/QRZ' is set, the
incorrect message is sent.
Following the upgrade, 'SendCallExchange Key' in writelog.ini was set to '2',
and should have remained at '10'.
This happened with the PJ2T contest log (prepared before the upgrade) and we
found/fixed it in the first few minutes of the contest. After the contest, I
discovered that when I loaded my existing PJ2/K8ND log (also prepared/used
before the contest) the problem *returned*, with the value of 'SendCallExchange
Key' set back to '2'!
Can someone explain this behavior? It would be bad for every team configuring
a log to have to change this value each time.
73, Jeff PJ2/K8ND
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|