WriteLog
[Top] [All Lists]

Re: [WriteLog] WL Hardware Handshaking?

To: "Joe Subich, W4TV" <lists@subich.com>
Subject: Re: [WriteLog] WL Hardware Handshaking?
From: Steve Woodruff <steve@n9oh.com>
Date: Thu, 19 Dec 2013 09:55:23 -0500
List-post: <writelog@contesting.com">mailto:writelog@contesting.com>
Hi Eric, Joe,

In the writelog.ini file, under the [configuration] section, you can set

RigPollInterval=300

or any other number... where this number represents the polling interval in
milliseconds.  The manual states that the default value is 500 milliseconds.

Thanks,

Steve N9OH


On Wed, Dec 18, 2013 at 7:19 PM, Joe Subich, W4TV <lists@subich.com> wrote:

>
> microHAM interfaces do not provide for application controlled
> handshake.  USB Interface II, USB Interface III, Digikeyer
> and Digikeyer II provide "fake handshake" (CTS to RTS) or
> a pull-up to +12V depending on the transceiver for those that
> require RTS be asserted.   microKEYER, microKEYER II, and MK2R+
> provide handshake between the controller and transceiver for
> those transceivers that support handshake - the interface will
> respect "CTS off" and not send data but generally keeps RTS
> asserted.
>
> Polling rate is strictly a function of the application - the
> microHAM interface forwards the application polls and commands
> as they are received.  I don't have access to an Orion to
> confirm but placing Writelog on the simulator and checking its
> polling rate with Orion selected indicates WriteLog polls the
> Orion at 100 ms intervals.  BTW, N1MM Logger shows the same
> polling rate.
>
> 73,
>
>    ... Joe, W4TV
>
>
>
> On 12/18/2013 6:28 PM, Eric Rosenberg wrote:
>
>> My station is a Ten Tec Orion 565 and a MicroHam Microkeyer II.
>>
>> I've had a  problem with Writelog jumping around in its frequency display
>> even if the radio hasn't changed frequency or is receiving, It is NOT an
>> RFI. issue.
>>
>> It turns out that the Orion needs hardware handshaking and a polling
>> interval of no less than 200 ms..
>>
>> My question... can these parameters be set in Writelog? If so, how?
>>
>> 73 & Thanks,
>> Eric W3DQ
>> _______________________________________________
>> WriteLog mailing list
>> WriteLog@contesting.com
>> http://lists.contesting.com/mailman/listinfo/writelog
>> WriteLog on the web:  http://www.writelog.com/
>>
>>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

<Prev in Thread] Current Thread [Next in Thread>